雪中裸体跪求助

lovess0407

[watermark] AutoECO Report
  y4 C( [) s4 Z. ?7 L* k( pFILE-A: E:\PROGRAM FILES\orcad\EX1.MAX
FILE-B: E:\PROGRAM FILES\ORCAD\EX1.MNL
2 T% X& _: Y, aIf "*EOF*" immediately follows, no changes were made
. J" W: ^/ k! _# eWarning: Unable to find footprint RAD/.200X.100/LS.100/.031 for comp C3.  Will try part name.
3 z/ d! Z0 t0 g5 g2 `4 [Warning: Unable to find footprint DIP.100/40/W.600/L2.100 for comp U1.  Will try part name.
) I6 d0 d# {" S; P7 g9 }...
6 i1 j  b/ a  W& x& e. f. G! w6 p...
  X. V+ j! Z# x% `& X; d...
AutoECO Error Report
FILE-A: E:\PROGRAM FILES\ORCAD\EX1.MAX
* s. _/ @9 K9 B- \8 C/ HFILE-B: E:\PROGRAM FILES\ORCAD\EX1.MNL
ERROR: No footprint found for comp C3
6 F. Q5 |2 W3 i* j9 g4 RERROR: No footprint found for comp U1
...
...
/ O8 A7 |) M- x8 }: y2 ^- w...
這是layout過程中顯示的錯誤報告,我有輸入PCB Footprint,
  O& R2 v  h! J' I搞不懂為何會這樣?請前輩指引,感恩

numbdemon

原帖由 lovess0407 于 2008-8-25 14:42 发表
1 ]. @" U6 A6 h5 L. b. r[watermark] AutoECO Report
FILE-A: E:\PROGRAM FILES\ORCAD\EX1.MAX
1 ^! U: r8 e  c9 W6 MFILE-B: E:\PROGRAM FILES\ORCAD\EX1.MNL
2 U" z( a6 v$ |: ~1 h6 EIf "*EOF*" immediately follows, no changes were made
$ c/ E7 k- y5 C& `- x' x: i( vWarning: Unable to find footprint RAD/ ...

从这段来看
ERROR: No footprint found for comp C3
3 q0 w1 L8 @: |! w+ i, Q  S& O& ^5 _: G& ~# DERROR: No footprint found for comp U1
应该是属性中没有PCB footprint所致